1. plotting
In this phase, the perimeter of the single piece that will compose the finished duct (linear or fitting) after
cutting and assembling is plotted on the panel.
2. cutting
Using the appropriate tools (manual or automatic)in this phase, the single pieces to be used
in the fabrication of the duct are cut from the panel.
3. bending
In this phase (required only for the production of ductfittings), indentations are applied to the piece of panel
allowing the panel to be adapted to the
shapes of the finished duct.
4. gluing
During gluing, all pieces produced above areassembled with the use of special glues and the
finished duct takes shape.
5. closing
In this phase,the duct is
trimmed and finished through
pressing and taping.
- Soft spatula (cod. 22SL01)
- Tape crease tool (cod. 22SG01)
- Cutter (cod. 22CT01)
- Soft spatula (cod. 22SL01)
- Tape crease tool (cod. 22SG01)
- Cutter (cod. 22CT01
- Pneumatic sealant gun (cod. 22PS05)
4. gluing
During gluing, all pieces produced above areassembled with the use of special glues
and the finished duct takes shape.
P3italy 
